Can a tc-780lc be used as a phono preamp?
By James Bradley
Can a tc-780lc be used as a phono preamp?
NOT A PHONO PREAMP!!! The TC-780LC provides up to 20dB of gain on any line level source, allowing longer cable runs or that “bump” you need to cure low volume issues. Or you can use it to add a volume control between a line level source and a power amp which has no level adjustment of its own.
Can a broken turntable be used as a phono preamp?
And even an old stereo unit that is “broken” may still be usable as an external phono preamp. If the unit powers on, try plugging the turntable into the “Phono” jacks and take the output from the “Tape Out” jacks, then plug those into an input on another system.
What kind of jacks are in a phono preamps?
Four jack sets are RCA type; the remaining two are 3.5mm stereo minijacks (the kind found on Discmen and MP3 players). This model allows the connection of up to three stereo aux level sources to one input on any mini-system or home theatre receiver.
What happens if you plug a phono into a receiver?
If you plug one of these into a Phono input on a receiver and it’s REALLY LOUD (and probably distorted), this is because the switch is in the wrong position and the signal is going through a phono preamp twice. Turn it to “Off” (or “Phono.”)
Which is better a phono preamp or a TC 750?
This product features better sound and performance than the phono preamps built into most component stereo receivers and amps! Compare the TC-750’s specs to those of pricier brands like NAD and Cambridge Audio; ours are as good or better.
Which is better technolink tc-750 or Cambridge Audio?
85dB S/N Plus A Lifetime Limited Warranty! This product features better sound and performance than the phono preamps built into most component stereo receivers and amps! Compare the TC-750’s specs to those of pricier brands like NAD and Cambridge Audio; ours are as good or better.
Is there a problem with the TCC 750lc?
Using TCC TC-750LC (input sensitivity knob) with a Project Carbon TT, Grado Red phono cartridge, and foam vibration pad. No hum or noise like others reported. I suspect the problem with others may be grounding between the pre-amp and TT.
Is there a sensitivity knob on the TCC 750?
Using TCC TC-750LC (input sensitivity knob) with a Project Carbon TT, Grado Red phono cartridge, and foam vibration pad. No hum or noise like others reported.
