How do you put pull cords on curtains?
By William Clark
How do you put pull cords on curtains?
Slide one end of the new cord over the top pulley on the end of the rod where you want the draw string to hang, and pull the cord toward the upper carrier. Slip the end of the cord through the leading edge of the upper carrier and tie a knot in the end of the cord to secure it to the carrier.
How does a traverse curtain rod work?
How do Traverse Curtain Rods Work? These mechanical rods operate by using small clips that move along a track that is embedded in the rod itself. This allows the curtain or drape to move smoothly along the rod and prevents any snagging that may happen with traditional curtain rods.
What are Pull String curtains called?
Traverse rods
Traverse rods have clips or eyes that move along a track embedded in a slot in the rod. The eyes have a small opening for the curtain pins and they’ll run evenly across the rod, with the number of eyes dependent on how long the rod is. A cord runs through the rod, too, and is attached to a master slide or pulley.
Do you have to use anchors for curtain rods?
You’ll need to use plastic wall anchors to provide proper support if you’re installing in drywall. Fasten the brackets to the walls using your drill or screwdriver. Having a hand tool ready often makes this job easier since it can be hard to use a larger electric drill when mounting curtain rod hardware to the wall.
How do you adjust cord in Traverse curtain rods?
Pull both masters to the right for drapes that will open to the right. Pull on one side of the cord that is knotted on the back of the overlap or underlap master, depending on the setup of your curtain rod. This removes the excess cord and provides tension. Tie a new knot in the cord close to the master.
What does a traverse rod for drapes do?
Daniels has written for many online publications and enjoys ghostwriting. Traverse rods consist of a pulley system that allows you to draw and close your drapes or curtains with a simple pull of a string. The drapes or curtains are hung on slides, also known as carriers, comprised of small pieces of plastic.
How do you replace a single string traverse rod?
Slide the carriers to one end of the rod. If you have a single string traverse rod, slide the carriers to the side that has the string. If working with a double string traverse rod, slide the carriers on the left to the end next to the left string.
Where is the primary carrier on a curtain rod?
Positioning the Master Carrier Pull on the draw cord to close the drape, the primary carrier will traverse until the drapery or curtain panel on that side is fully extended. If the rod was properly installed to match the width of the curtain, the carrier will be in the center of the rod. Center Draw Traverse Rod Seen From the Back
